2021-08-26

Brake Pad Kit - Front (Base Brakes) (Remove and Replace)

Correction code 33010702 0.48 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so.NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

Remove

Informational PurposesAn informational icon, calling your attention
Note
For detailed brake specifications, see Brakes.
  1. Remove the LH front wheel. See Wheel Assembly (Remove and Install).
  2. Remove the brake pad retaining pins that attach the anti-rattle spring from the LH front brake caliper.
  3. Remove the front brake pads from the LH front brake caliper.
  4. Use the caliper spreader kit or similar tool to gently push the piston back into the caliper.
  5. Clean the caliper pins and anti-rattle spring with soapy water and a hand brush.
  6. Repeat step 1 through step 5 for the RH front brake caliper.

Install

  1. Apply an even layer of Silaramic lubricant to the brake caliper slides.
  2. Install the LH front brake pads to the LH front brake caliper.
  3. Install the brake pad retaining pins that attach the anti-rattle spring.
  4. Install the LH front wheel. SeeWheel Assembly (Remove and Install).
  5. Repeat step 1 through step 4 for the RH front brake caliper.
  6. Pump the brake pedal 3-5 times to seat the pads against the brake rotor until the brake pedal feels firm.
  7. Burnish the brake pads. See Brake Pads - Burnishing.