Speaker - Pedestrian Warning (Remove and Replace)
Correction code
17541002
0.24
NOTE: Unless otherwise explicitly
stated in the procedure, the above correction code and FRT reflect all of the work
required to perform this procedure, including the linked procedures. Do not stack correction codes unless
explicitly told to do so.
NOTE: See Flat Rate
Times to learn more about FRTs and how they are created. To provide feedback on
FRT values, email ServiceManualFeedback@tesla.com.
NOTE: See Personal Protection to make sure wearing proper PPE when
performing the below procedure.
- 2023-09-12: Optimized the procedure to improve efficiency.
Remove
- Remove the RH front wheel. See Wheel Assembly (Remove and Install).
- Remove the clips (x9) that hold the RH front wheel liner to fascia, and move the wheel liner aside for access.
- Remove the clip that attaches the harness to the pedestrian warning speaker assembly.
-
Release the locking tab by sliding it away from the
connector, then depress the grey locking tab to
release the pedestrian warning speaker
connector.
NoteThe connector access may vary depending on the version of the super horn audio speaker installed on the vehicle. You may need to use a pocket screwdriver or a miniature pick to release the red locking tab, which is covered by an anti-tampering feature.
-
Remove
the screws (x3) that attach the pedestrian warning
speaker assembly to the front fascia, and then
remove the pedestrian warning speaker from the
fascia.1.8 Nm (1.3 lbs-ft)TIpUse of the following tool(s) is recommended:
- Flex head ratchet/flex head torque wrench
- 2 in extension
- Torx T25 socket
- Ratchet/torque wrench
Install
-
Install the screws (x3) that attach the pedestrian
warning speaker assembly to the front fascia.1.8 Nm (1.3 lbs-ft)TIpUse of the following tool(s) is recommended:
- 2 in extension
- Torx T25 socket
- Ratchet/torque wrench
- Engage the locking tab to connect the pedestrian warning speaker connector.
- Install the clip that attaches the harness to the pedestrian warning speaker assembly.
- Install the clips (x9) that hold the RH front wheel liner to fascia.
- Install the RH front wheel. See Wheel Assembly (Remove and Install).