09/07/2018 15:25:10

Beam - 12V Battery (Dual Motor) (Remove and Replace)

Correction code 17012712 1.56 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so.NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

Remove

  1. Remove the 2nd row lower seat cushion. See Seat Cushion - Lower - 2nd Row (Remove and Replace).
  2. Remove the rear underhood apron. See Underhood Apron - Rear (Remove and Replace).
  3. Remove the cabin intake duct. See Duct - Cabin Intake (Remove and Replace).
  4. Remove the underhood storage unit. See Underhood Storage Unit (Remove and Replace).
  5. Remove the LH and RH wiper arms. See Wiper Arms (Remove and Replace).
  6. Remove the LH and RH shock tower covers. See Cover - Shock Tower - LH (Remove and Replace).
  7. Remove the cowl screen panel. See Panel - Cowl Screen (Remove and Replace).
  8. Disconnect 12V power. See 12V/LV Power (Disconnect and Connect).
  9. Remove the 12V auxiliary battery. See 12V/LV Battery (Remove and Replace).
  10. Remove the front body controller module. See Module - Body Controller - Front (Dual Motor) (Non-Heat Pump) (Remove and Replace).
  11. Release the clips that attach the coolant hoses and electrical harnesses to the 12V battery beam.
  12. Remove the bolts that attach the 12V battery beam to the vehicle.
    9 Nm (6.6 lbs-ft)
  13. Remove the 12V battery bracket and 12V battery beam from the vehicle.
    Informational PurposesAn informational icon, calling your attention
    Note
    Carefully slide the beam toward the RH side of the vehicle, and then lift the LH side of the beam to remove the assembly.
  14. Remove the bolts that attach the 12V battery beam to the 12V battery bracket, and then set the bracket aside.
    9 Nm (6.6 lbs-ft)

Install

Installation procedure is the reverse of removal, except for the following:

  • Replace all nyloc nuts.
  • Replace all patchbolts.