25/10/2022 09:00:48

USB Hub - Center Console - Front (Remove and Replace)

Correction code 21260402 0.30 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so.NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

Torque Specifications

Table 1. Torque Specifications: USB Hub - Center Console - Front (Remove and Replace)
Description Torque Value Recommended Tools Reuse/Replace Notes
Bolts that attach the USB hub to the center console
1.1 Nm (.8 lbs-ft)
  • Torx T20 socket
  • 4 in extension
Reuse

Remove

  1. Remove the center console. See Center Console (Remove and Install).
    Informational PurposesAn informational icon, calling your attention
    Note
    It is not necessary to remove the center console assembly from the vehicle; maneuver the assembly away from the instrument panel to access the USB hub.
  2. Disconnect the electrical wiring harness connector from the USB hub.
  3. Release the clips that attach the electrical harness to the USB hub.
  4. Remove the bolts that attach the USB hub to the center console, and then remove the USB hub from the center console.
    1.1 Nm (.8 lbs-ft)
    Tip: Use of the following tool(s) is recommended:
    • Torx T20 socket
    • 4 in extension

Install

Installation procedure is the reverse of removal.