22/05/2020 13:57:36

Insert - Front Bin - Center Console (Remove and Replace)

Correction code 15195602 0.90 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so.NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

Torque Specifications

Table 1. Torque Specifications: Insert - Front Bin - Center Console (Remove and Replace)
Description Torque Value Recommended Tools Reuse/Replace Notes
Reuse
Screws that attach the cup holder lower assembly to the center console
1.1 Nm (.8 lbs-ft)
  • Torx T20 socket
  • 4 in extension
Reuse
Screws that attach the center console front bin insert to the center console
1.1 Nm (.8 lbs-ft)
  • Torx T20 socket
  • 4 in extension
Reuse

Remove

  1. Remove the LH front floormat.
  2. Remove the center console. See Center Console (Remove and Install)
  3. Raise the center console armrest for access.
  4. Remove the LH and RH center console decor trim. See Decor Trim - Center Console - LH (Remove and Replace).
  5. Remove the screws that attach the LH bright strip to the center console.
    Informational PurposesAn informational icon, calling your attention
    Note
    Use of the following tool(s) is recommended:
  6. Release the 6 tabs that attach the bright strip to the center console, and then remove the bright strip.
  7. Remove the screws that attach the RH bright strip to the center console.
  8. Release the 6 tabs that attach the bright strip to the center console, and then remove the bright strip.
  9. Release the clips that attach the cup holder decor to the center console.
  10. Disconnect the electrical connector from security controller, and then remove the cup holder decor.
  11. Disconnect the connectors from the 12V outlet and the puddle light.
  12. Remove the screws that attach the cup holder assembly to the center console.
    1.1 Nm (.8 lbs-ft)
    Informational PurposesAn informational icon, calling your attention
    Note
    Use of the following tool(s) is recommended:
    • Torx T20 socket
    • 4 in extension
  13. Release the clips that attach the cup holder assembly to the center console, and then remove the cup holder assembly from the center console.
  14. Disconnect the connectors from the RH side of the center console.
  15. Disconnect the connectors from the USB controller.
  16. Release the clips that attach the cables to the center console front bin insert.
  17. Remove the screws that attach the center console front bin insert to the center console.
    1.1 Nm (.8 lbs-ft)
    Informational PurposesAn informational icon, calling your attention
    Note
    Use of the following tool(s) is recommended:
    • Torx T20 socket
    • 4 in extension
  18. Pull up to release the clips (x4) that attach the center console front bin insert to the center console, and then remove the bin.

Install

Installation procedure is the reverse of removal.