12/09/2024 09:13:09

Antenna - GPS (Remove and Replace)

Correction code 21320102 0.18 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so.NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

  • 2024-09-12: Added note that it is unnecessary to disconnect the harness from triple camera assembly.

Remove

  1. Remove the forward facing camera. See Camera - Triple - Forward Facing (Remove and Replace).
    Informational PurposesAn informational icon, calling your attention
    Note
    It is not necessary to disconnect the electrical harness from the triple camera assembly. After removing the fasteners that attach the triple camera assembly to the vehicle, allow the assembly to hang from the harness.
  2. Disconnect the electrical harness from the humidity and temperature sensor connector.
  3. Disconnect the electrical harness from the GPS antenna connector.
  4. Remove the screw that attaches the electrical harness to the windshield bracket, and then move the electrical harness aside.
    1 Nm (.7 lbs-ft)
  5. Remove the screw that attaches the GPS antenna to the bracket, and then remove the GPS antenna from the vehicle.
    1 Nm (.7 lbs-ft)

Install

Installation procedure is the reverse of removal, except for the following: