2022-07-07
Clean the Blower Motor
Correction code
18103205
0.24
NOTE: Unless otherwise explicitly
stated in the procedure, the above correction code and FRT reflect all of the work
required to perform this procedure, including the linked procedures. Do not stack correction codes unless
explicitly told to do so.NOTE: See Flat Rate
Times to learn more about FRTs and how they are created. To provide feedback on
FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when
performing the below procedure.
Remove
- Remove the underhood storage unit. See Underhood Storage Unit (Remove and Replace).
- Remove the fresh air intake assembly. See Duct - Fresh Intake (Remove and Replace).
- Turn the HVAC on, then off to open the fresh air inlet duct and gain access to the blower.
- Remove any loose debris from the fresh air inlet seal.
-
Use an air gun to blow shop
air into the HVAC module assembly to remove dust particles from the
blower.
- Remove the cabin filter. See Filter - Cabin (Remove and Replace).
Install
- Install the cabin filter. See Filter - Cabin (Remove and Replace).
- Install the fresh air intake assembly. See Duct - Fresh Intake (Remove and Replace).
- Install the underhood storage unit. See Underhood Storage Unit (Remove and Replace).