15/12/2023 01:29:14

Cap - 12V - Ancillary Bay (Remove and Replace)

Correction code 13053602 0.12 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so.NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

Remove

  1. Remove the 2nd row lower seat cushion. See Seat Cushion - Lower - 2nd Row (Remove and Replace).
  2. Lift the 12V cap straight up from over the high voltage controller connector on the RH side of the ancillary bay, and then remove the 12V cap from the vehicle.

Install

Installation procedure is the reverse of removal.