04/01/2024 04:42:14

Panel - Aero Shield - Mid (Remove and Replace)

Correction code 12030502 0.18 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so.NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

2024-01-04: Updated consumables information.

Torque Specifications

Table 1. Torque Specifications: Panel - Aero Shield - Mid (Remove and Replace)
Description	Torque Value	Recommended Tools	Reuse/Replace	Notes
Bolt that attaches the mid aero shield panel to the vehicle	5.5 Nm (4.1 lbs-ft)	10 mm socket 4 in extension Ratchet/torque wrench	Reuse	Note Apply threadlocker to the threads of each bolt prior to installation.

Remove

Raise and support the vehicle. See Raise Vehicle - 2 Post Lift.
Remove the bolts (x13) that attach the mid aero shield panel to the vehicle, and then remove the panel from the vehicle.
Inspect the HV battery vent assemblies at the rear of the HV battery for the presence of breathers.
If any breathers are missing, install them now. See Breathers - HV Battery (Remove and Replace).

Note
After installing the breather(s), if necessary, return to the procedure that required removal of the mid aero shield panel.

Install

Apply a thin bead of threadlocker to the threads of the bolts that attach the mid aero shield panel to the vehicle.
Install the mid aero shield panel to the underside of the vehicle, and then install the bolts that attach the panel to the vehicle.
5.5 Nm (4.1 lbs-ft)
Lower the vehicle. See Raise Vehicle - 2 Post Lift.