24/07/2020 13:53:21
Light - License Plate (Remove and Replace)
Correction code
17402602
0.12
NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so.NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.
Remove
- Remove the trunk lid trim. See Trim - Lid - Trunk (Remove and Replace).
-
Disconnect the electrical connector from the license plate light.
-
Push the license plate light towards the RH of the vehicle to compress the clip, and then compress the clip on the other side of the light to remove the light.
Install
Installation procedure is the reverse of removal.