27/05/2020 11:14:51

Latch - Trunk (Remove and Replace)

Correction code 11355002 0.12 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so.NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

Torque Specifications

Table 1. Torque Specifications: Latch - Trunk (Remove and Replace)
Description Torque Value Recommended Tools Reuse/Replace Notes
Bolts that attach the trunk latch to the trunk lid
8 Nm (5.9 lbs-ft)
  • 10 mm socket
 Reuse

Remove

  1. Remove the trunk lid trim. See Trim - Lid - Trunk (Remove and Replace).
  2. Disconnect the electrical connector from the latch.
  3. Remove the bolts that attach the latch to the trunk lid, and then remove the latch from the vehicle.
    Informational PurposesAn informational icon, calling your attention
    Note
    Use of the following tool(s) is recommended:
    • 10 mm socket

Install

  1. Position the latch and loosely install the bolts that attach the latch to the trunk lid.
    Informational PurposesAn informational icon, calling your attention
    Note
    Use of the following tool(s) is recommended:
    • 10 mm socket
  2. Connect the electrical connector to the latch.
  3. Close the trunk to check gap/flush and, if necessary, perform adjustments.
  4. Open the trunk and torque the bolts that attach the latch to the trunk lid.
    8 Nm (5.9 lbs-ft)
    Informational PurposesAn informational icon, calling your attention
    Note
    Use of the following tool(s) is recommended:
    • 10 mm socket
  5. Install the trunk lid trim. See Trim - Lid - Trunk (Remove and Replace).