2018-02-09

Bracket - Compressor (Non-Heat Pump) (Remove and Replace)

Correction code 18203202 0.48 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so.NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

Remove

  1. Remove the 2nd row lower seat cushion. See Seat Cushion - Lower - 2nd Row (Remove and Replace).
  2. Remove the rear underhood apron. See Underhood Apron - Rear (Remove and Replace).
  3. Remove the cabin intake duct. See Duct - Cabin Intake (Remove and Replace).
  4. Remove the hood latch cover. See Cover - Hood Latch (Remove and Replace).
  5. Remove the underhood storage unit. See Underhood Storage Unit (Remove and Replace).
  6. Disconnect 12V power. See 12V/LV Power (Disconnect and Connect).
  7. Support the A/C compressor to the thermal beam.
  8. Remove the bolts that attach the A/C compressor mount to the A/C compressor.
    10 Nm (7.4 lbs-ft)
  9. Remove the bolts that attach the A/C compressor mount to the thermal beam, and then remove the A/C compressor mount from the vehicle.
    10 Nm (7.4 lbs-ft)

Install

Installation procedure is the reverse of removal.