04/09/2024 13:05:30

Cover - Rear Suspension - LH (Remove and Replace)

Correction code 31032012 0.12 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so.NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

Torque Specifications

Table 1. Torque Specifications: Cover - Rear Suspension - LH (Remove and Replace)
Description Torque Value Recommended Tools Reuse/Replace Notes
Bolt that attaches the rear suspension cover to the lower rear control arm assembly
6 Nm (4.4 lbs-ft)
  • 10 mm socket
  • 2 in extension
Replace Replace with new patched bolt (PN - 1484170-00-A)

Remove

  1. Raise and support the vehicle. See Raise Vehicle - 2 Post Lift.
  2. Remove the bolt that attaches the rear suspension cover to the LH lower rear control arm assembly.
    6 Nm (4.4 lbs-ft)
    Tip: Use of the following tool(s) is recommended:
    • 10 mm socket
    • 2 in extension
  3. Release the tabs (x2) that attach the rear suspension cover to the LH lower rear control arm assembly, and then remove the rear suspension cover from the vehicle.

Install

Installation procedure is the reverse of removal.