29/04/2020 15:11:01
End Panel - Center Console (Remove and Replace)
Correction code 15195002 0.24 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so.NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.
Torque Specifications
| Description | Torque Value | Recommended Tools | Reuse/Replace | Notes |
|---|---|---|---|---|
| Bolts that attach the center console end panel to the center console |
 1.1 Nm (.8 lbs-ft) |
|
Reuse |
Remove
- Remove the center console lower rear panel. See Panel - Lower Rear - Center Console (Remove and Replace).
- Remove the center console air vent panel. See Assembly - Rear Vent - Center Console (Remove and Replace).
-
Remove the bolts (x2) and
release the clips (x6) that attach the center console end panel to the
center console, and then remove the end panel from the console.1.1 Nm (.8 lbs-ft)Tip: Use of the following tool(s) is recommended:
- Torx T20 socket
- 4 in extension
Install
Installation procedure is the reverse of removal.