2019-02-07

Horn - High Tone (Remove and Replace)

Correction code 17530102 0.60 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so.NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

Remove

  1. Remove the rear underhood apron. See Underhood Apron - Rear (Remove and Replace).
  2. Remove the cabin intake duct. See Duct - Cabin Intake (Remove and Replace).
  3. Remove the hood latch cover. See Cover - Hood Latch (Remove and Replace).
  4. Remove the underhood storage unit carpet. See Carpet - Underhood Storage (Remove and Install).
  5. Remove the underhood storage unit. See Underhood Storage Unit (Remove and Replace).
  6. Remove the LH and RH front wheels. See Wheel Assembly (Remove and Install).
  7. Remove the front aero shield. See Panel - Aero Shield - Front (Remove and Replace).
  8. Remove the front fascia. See Fascia - Front (Remove and Install).
  9. Disconnect the electrical connector from the high tone horn.
  10. Remove the bolt that attaches the high tone horn to the carrier, and then remove the horn from the vehicle.
    9 Nm (6.6 lbs-ft)

    North America

    EMEA

Install

Installation procedure is the reverse of removal.