04/09/2024 15:16:56

Shield - Dust - Brake - Rear - LH (Remove and Replace)

Correction code 33011802 0.30 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so.NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

  • 2024-05-28: Updated EPB Service Mode reference.

Torque Specifications

Table 1. Torque Specifications: Shield - Dust - Brake - Rear - LH (Remove and Replace)
Description Torque Value Recommended Tools Reuse/Replace Notes
LH rear brake dust shield to the knuckle
8 Nm (5.9 lbs-ft)
  • Torx T30 socket
  • 4 in extension
  • Ratchet/torque wrench
Reuse
Bolts that attach the rear brake caliper to the knuckle
83 Nm (61.2 lbs-ft)
  • External Torx E18
  • Ratchet/torque wrench
Replace

Remove

Informational PurposesAn informational icon, calling your attention
Note
This procedure describes the removal and installation of the revised rear brake dust shield (1044665-00-C (LH) and 1044666-00-C (RH) or newer).
  1. Remove any wheel caps or covers, and then loosen the LH rear wheel lug nuts. Do not remove the wheel at this time. See Wheel Assembly (Remove and Install).
  2. Raise and support the vehicle. See Raise Vehicle - 2 Post Lift.
  3. Place the vehicle into EPB Service Mode. See Parking Brake - Caliper - Rear - LH (Release).
  4. Remove the LH rear wheel. See Raise Vehicle - 2 Post Lift.
  5. Remove the LH rear brake rotor. See Brake Rotor - Rear - LH (Remove and Replace).
  6. Remove the bolts that attach the LH rear brake dust shield to the knuckle, and then remove the dust shield from the vehicle.

Install

  1. Position the LH rear brake dust shield on the knuckle, and then install the bolts that attach the dust shield to the knuckle.
    8 Nm (5.9 lbs-ft)
  2. Install the LH rear brake rotor and caliper, but do not perform any road tests. See Brake Rotor - Rear - LH (Remove and Replace).
  3. Position the LH rear wheel on the vehicle, and then hand-tighten the LH rear wheel lug nuts.
  4. Lower the vehicle, and then shift the vehicle into Park (this will disable EPB Service Mode).
  5. Tighten LH rear wheel lug nuts. See Wheel Assembly (Remove and Install).
  7. Install any wheel caps or covers that were removed.