2022-04-12

Diffuser - Rear Fascia (Remove and Replace)

Correction code 12030802 0.24 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so.NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

Torque Specifications

Table 1. Torque Specifications: Diffuser - Rear Fascia (Remove and Replace)
Description Torque Value Recommended Tools Reuse/Replace Notes
Bolts that attach the rear fascia diffuser to the vehicle
4 Nm (2.9 lbs-ft)
  • 10 mm socket
  • 2 in extension
Reuse
Bolts that attach the rear fascia diffuser to the outer edge of the rear fascia
3 Nm (2.2 lbs-ft)
  • 10 mm socket
Reuse
Bolts that attach the rear fascia diffuser to the inside of the rear fascia
3 Nm (2.2 lbs-ft)
  • 10 mm socket
Reuse

Remove

  1. Raise and support the vehicle. See Raise Vehicle - 2 Post Lift.
  2. Remove the clips that attach the rear portion of the LH and RH rear wheel liners to the body.
  3. Remove the mid aero shield panel. See Panel - Aero Shield - Mid (Remove and Replace).
  4. Remove the fastener covers, and then remove the bolts that attach the rear fascia diffuser to the vehicle.
    4 Nm (2.9 lbs-ft)
    Informational PurposesAn informational icon, calling your attention
    Note
    Newer vehicles are not equipped with the front, middle bolt.
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • 10 mm socket
    • 2 in extension
  5. Remove the bolts that attach the rear fascia diffuser to the outer edge of the rear fascia.
    3 Nm (2.2 lbs-ft)
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • 10 mm socket
  6. Remove the bolts that attach the rear fascia diffuser to the inside of the rear fascia.
    3 Nm (2.2 lbs-ft)
    Informational PurposesAn informational icon, calling your attention
    Note
    Reach into the loosened rear fascia diffuser to access these bolts.
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • 10 mm socket
  7. Release the tabs that attach the rear fascia diffuser to the rear fascia, and then remove the diffuser.

Install

Installation procedure is the reverse of removal.