17/07/2024 02:38:16

NVH Tape - Brake Pads - Front (EMEA) (Retrofit)

Correction code 33010706 0.20 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so.NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

  • 2024-07-15: Updated procedure for pre-cut stickers and added region information.
  • 2024-06-25: Updated notes.
  • 1994754-00-A STICKER FOR CALIPER
  • 1021050-00-A PRIMER, TAPE, 3M, No. 94

Procedure

Informational PurposesAn informational icon, calling your attention
Note
This is an additional procedure, to prevent NVH issues. This procedure is for the EMEA market. Add this correction code as an extra procedure to the service activity.
Informational PurposesAn informational icon, calling your attention
Note
This additional procedure can be performed when the front brake pads have been removed and before the pads are being installed.
  1. Clean the back side of the front brake pads (x4) and the surfaces of the brake caliper pistons (x8) using brake cleaner.
  2. Apply primer to the back side of the front brake pads (x4), and then allow 5 minutes to dry.
  3. Align the pre-cut NVH sticker to the back side of the front brake pads (x4), and then apply pressure on the stickers to adhere them to the brake pads.
  4. Remove the protective cover from the NVH sticker applied to the brake pads (x4).
  5. Clean the brake caliper retaining pins (x4) using a hand brush and soapy water, and then apply an even layer of Silaramic lubricant to the brake caliper retaining pins.
  6. Proceed with the installation of the front brake pads.