12/04/2023 13:12:41

Harness - Electronic Parking Brake (EPB) - LH (Remove and Replace)

Correction code 17102102 0.12 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so.NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

Torque Specifications

Table 1. Torque Specifications: Harness - Electronic Parking Brake (EPB) - LH (Remove and Replace)
Description	Torque Value	Recommended Tools	Reuse/Replace	Notes
Bolt that attaches the LH rear EPB harness bracket to the LH rear caliper	5 Nm (3.7 lbs-ft)	10 mm socket 4 in extension	Reuse
Bolt that attaches the LH rear EBP harness bracket to the body	5 Nm (3.7 lbs-ft)	10 mm socket	Reuse

Remove

Use a floor jack and a jack stand to raise and support the vehicle. See Raise Vehicle - Floor Jack (Mobile Service).
Remove the LH rear wheel. See Wheel Assembly (Remove and Install).
Remove the clips (x3) and push nut that attach the LH rear wheel liner to the vehicle, and then lift the liner for access to the harness.
Release the connector lock, and then disconnect the LH electronic parking brake caliper electrical connector.
Remove the bolt that attaches the LH rear EPB harness bracket to the LH rear caliper.
5 Nm (3.7 lbs-ft)
Tip: Use of the following tool(s) is recommended:
- 10 mm socket
- 4 in extension
Remove the bolt that attaches the LH rear EPB harness bracket to the body.
5 Nm (3.7 lbs-ft)
Tip: Use of the following tool(s) is recommended:
- 10 mm socket
Release the connector lock, and then disconnect the LH rear electronic parking brake harness from the rear main body harness.