18/11/2019 12:45:32

Flip Door - Tether Anchor - LH (Remove and Replace)

Correction code 15243102 0.36 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so.NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

Remove

  1. Remove the package tray trim. See Trim - Package Tray (Remove and Replace).
  2. If equipped with a foam block, use a retractable blade knife to remove the foam block from the underside of the tether anchor flip door.
    Warning IconA warning icon, calling your attention to a possibly risky situation
    Warning
    Wear cut-resistant gloves when performing this step.
  3. Use diagonal cutters to remove the retaining clips that attach the tether anchor flip door to the package tray trim.
    Warning IconA warning icon, calling your attention to a possibly risky situation
    Warning
    Wear eye protection and cut-resistant gloves when performing this step.
  4. Remove the tether anchor flip door.

Install

  1. Place the new tether anchor flip door onto the package tray so that the standoffs are aligned.
  2. Install new retaining clips to attach the tether anchor to the package tray trim.
    Tip: Use a 7 mm socket to push down and secure the retaining clips.
  3. If the tether anchor flip door had a foam block, use a glue gun to apply glue to the areas shown and then install the foam block. Allow the glue to fully dry before continuining.
  4. Install the package tray trim. See Trim - Package Tray (Remove and Replace).