06/07/2023 02:20:32

Trim - Side Rail - LH (Remove and Install)

Correction code 15186601 0.12 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so.NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

  • 2023-07-06: Added a video in step 3 of Remove part.

Remove

  1. Open the LH rear door.
  2. Release the push clips (x2) that attach the LH side rail trim to the LH side rail.
    Tip: Release the top clip first (closest to the coat hanger) and work towards the trunk.
  3. Release the side rail trim tethers (x2) from the side rail trim one at a time by twisting and pulling away from the trim.
    Warning IconA warning icon, calling your attention to a possibly risky situation
    CAUTION
    Do not remove the side rail trim tethers from the body side. If removed from the body side, the tethers will have to be replaced.
  4. Remove the side rail trim from the vehicle.
    Informational PurposesAn informational icon, calling your attention
    Note
    Remove any remaining LH side rail trim push clips from the LH side rail, and remove all push clips from the LH side rail trim.

Install

  1. Install new push clips (x2) onto the LH side rail trim.
  2. Make sure that the side rail tethers are undamaged, and at the correct positions on the LH side rail.
  3. Hook the side rail trim tethers (x2) on the side rail trim, and then position the side rail trim on the vehicle.
  4. Firmly fasten the push clips that attach the LH side rail trim to the LH side rail.
    Informational PurposesAn informational icon, calling your attention
    Note
    Fasten the top clip first near the coat hanger, and work towards the trunk.
    Important: Make sure each clip makes an audible snap as they engage with the side rail. If there is no audible snap, the clip has not properly attached. Remove the side rail trim, inspect the clips, replace any damaged clips, and then re-install the trim.