2024-02-01
Bracket - Manual Release Cable - Charge Port (Remove & Replace)
Correction code
44012142
0.12
NOTE: Unless otherwise explicitly
stated in the procedure, the above correction code and FRT reflect all of the work
required to perform this procedure, including the linked procedures. Do not stack correction codes unless
explicitly told to do so.NOTE: See Flat Rate
Times to learn more about FRTs and how they are created. To provide feedback on
FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when
performing the below procedure.
Remove
- Remove the trunk garnish. See Garnish - Trunk (Remove and Replace).
- Disconnect the LH trunk light. See Light - Trunk (Remove and Replace).
-
With a small flat head screwdriver, pull the manual release cable off from the hold
down clip.
-
Use a small flat head screwdriver to release the tab.
-
Remove the charge port manual release bracket from the vehicle.
Install
-
Install the tab that attaches the charge port manual release bracket to the
vehicle.
-
Push down the manual release cable into the locking tab.
- Connect the LH trunk light. See Light - Trunk (Remove and Replace).
- Install the trunk garnish. See Garnish - Trunk (Remove and Replace).