2026-07-02

Module - Cooling Fan (Non-Heat Pump) (Remove and Replace)

Correction code 18201302 2.16 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure. NOTE: See Ergonomic Precautions for safe and healthy working practices.

  • 2026-07-02: Added note that correction code for refrigerant recovery/recharge must be added separately.
Informational PurposesAn informational icon, calling your attention
Note
This procedure requires the A/C Refrigerant (Recovery and Recharge) procedure to be performed. If not already automatically added to the Service Visit, add correction code 18200102 as a separate correction within the same activity to the Service Visit.

Remove

  1. Remove the cooling fan module. See Module - Cooling Fan (Remove and Install).
  2. Release the clips (x14) that attach the active grille shutter to the cooling fan module, and then remove the active grille shutter from the module.
  3. Remove the screws (x2) that attach the radiator to the cooling fan module.
    10 Nm (7.4 lbs-ft)
  4. Release the clip that attaches the radiator to the cooling fan module, and then remove the radiator from the cooling fan module.
  5. Release the clips (x2) that attach the condenser to the cooling fan module, and then remove the condenser from the cooling fan module.

Install

Installation procedure is the reverse of removal.