Condenser (Remove and Replace)
Correction code
18201002
2.70
NOTE: Unless otherwise explicitly
stated in the procedure, the above correction code and FRT reflect all of the work
required to perform this procedure, including the linked procedures. Do not stack correction codes unless
explicitly told to do so.
NOTE: See Flat Rate
Times to learn more about FRTs and how they are created. To provide feedback on
FRT values, email ServiceManualFeedback@tesla.com.
NOTE: See Personal Protection to make sure wearing proper PPE when
performing the below procedure. See Ergonomic Precautions for safe and healthy working practices.
Remove
- Remove the cooling fan module. See Module - Cooling Fan (Remove and Install).
-
Release the clips (x14) that attach the active grille shutter to the cooling fan module, and then remove the active grille shutter from the module.
-
Remove the screws (x2) that attach the radiator to the cooling fan module.
10 Nm (7.4 lbs-ft) -
Release the clip that attaches the radiator to the cooling fan module, and then remove the radiator from the cooling fan module.
-
Release the clips (x2) that attach the condenser to the cooling fan module, and then remove the condenser from the cooling fan module.
Install
Installation procedure is the reverse of removal.