13/04/2023 02:13:47
Switch - Exterior Release - Trunk (Remove and Replce)
Correction code
11355602
0.12
NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so.NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.
- 2023-04-13: Added reference to license plate removal and updated DAS reset instructions.
Remove
- If necessary, remove the license plate and bracket. See Bracket - License Plate - Rear (EMEA) (Remove and Replace).
- Remove the trunk lid trim. See Trim - Lid - Trunk (Remove and Replace).
-
Disconnect the electrical
connectors from the trunk exterior release switch and the rear facing
camera.
-
Release the clips that attach the trunk exterior release switch to the
liftgate.
-
Remove the switch from the vehicle.
Install
- Install the switch to the vehicle.
-
Install new clips that attach the trunk exterior release switch to the
trunk.
-
Connect the electrical connectors to the trunk exterior release switch and
the rear facing camera.
- Install the trunk lid trim. See Trim - Lid - Trunk (Remove and Replace).
- Install the license plate and bracket, if applicable. See Bracket - License Plate - Rear (EMEA) (Remove and Replace)
- Enable Service Mode. See Service Mode.
- Reset the vehicle DAS using the touchscreen: .
- Disable Service Mode. See Service Mode.
- Verify that the rear facing camera works properly.