09/02/2024 14:07:21
Software Update
Correction code 00020003 0.05 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so.NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.
- 2023-06-08: Changed "firmware" to "software".
Procedure
- Verify that network connectivity is available to the vehicle by the words "3G", "4G", "LTE", or the WiFi icon appearing in the upper right corner of the touchscreen.
-
Verify that there is an
orange down arrow in the upper right corner of the vehicle
touchscreen.
- If the down arrow is displayed, skip to step 4.
- If no down arrow is displayed, the vehicle software might be at the latest level for the vehicle, or no request for the latest vehicle software has been made. Continue to the next step.
-
Touch Controls and
then touch Software to request the latest vehicle software.
NoteIf the text "Your car software is up to date as of …." appears above Software Update Preference, the vehicle is already configured with the latest software.NoteIf the orange down arrow does not appear in the upper right corner of the touchscreen within 10 seconds, the vehicle' network connectivity might be unreliable.
-
Touch the orange down arrow
to start the vehicle software download.
NoteWhen the download starts, the arrow turns green. After the download completes, the green arrow is replaced by the yellow clock icon. If the clock icon does not appear within 45 minutes, the vehicle's network connectivity might be unreliable.
- Touch the yellow clock icon, and then touch INSTALL NOW.
-
Verify that the software
update was successful.
- If the update failed, repeat from step 5.
- If the update succeeded, and the update was performed as one step of another service procedure, return to that procedure.
- If the update succeeded, and the update was performed as a stand-alone procedure, it is now complete.