Bracket - Edge Support - Seat Cushion - 2nd Row - LH (Remove and Replace)
Correction code
13050612
0.12
NOTE: Unless otherwise explicitly
stated in the procedure, the above correction code and FRT reflect all of the work
required to perform this procedure, including the linked procedures. Do not stack correction codes unless
explicitly told to do so.NOTE: See Flat Rate
Times to learn more about FRTs and how they are created. To provide feedback on
FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when
performing the below procedure.
Torque Specifications
| Description | Torque Value | Recommended Tools | Reuse/Replace | Notes |
|---|---|---|---|---|
| Bolt that attaches the 2nd row seat cushion edge support bracket to the vehicle |
 10 Nm (7.4 lbs-ft) |
|
Reuse |
Remove
- Open all four doors.
- Lower all four windows.
- Move both front seats fully forward.
- Remove the 2nd row lower seat cushion. See Seat Cushion - Lower - 2nd Row (Remove and Replace).
- Remove the LH rear sill panel trim. See Trim - Sill Panel - Rear - LH (Remove and Replace).
-
Release the clip that attaches the electrical harness to the 2nd row seat
cushion edge support bracket.
-
Remove the bolts that attach the 2nd row seat cushion edge support bracket
to the vehicle, and then remove the bracket from the vehicle.
TIpUse of the following tool(s) is recommended:
- 10 mm socket
- 4 in extension
- Ratchet/torque wrench
Install
Installation procedure is the reverse of removal.