Fan - Condenser (Remove and Replace)
Correction code
18201502
1.32
NOTE: Unless otherwise explicitly
stated in the procedure, the above correction code and FRT reflect all of the work
required to perform this procedure, including the linked procedures. Do not stack correction codes unless
explicitly told to do so.NOTE: See Flat Rate
Times to learn more about FRTs and how they are created. To provide feedback on
FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when
performing the below procedure.
Remove
- Remove the active grille shutter. See Active Grille Shutter (Heat Pump) (Remove and Replace).
- Release the upper and lower locking tabs that attach the radiator to the cooling fan and shroud assembly , and then remove the radiator from the cooling fan and shroud assembly.
- Remove the bolts and isolators from the cooling fan and shroud assembly.
Install
Installation procedure is the reverse of removal.