2026-08-09

Wheel Arch Liner - Front - LH (Remove and Replace)

Correction code 12010902 0.24 NOTE: Unless otherwise explicitly stated in the procedure, the correction code and its associated FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure. NOTE: See Ergonomic Precautions for safe and healthy working practices.

    Equipment:
    • 1133569-00-A Pliers, Clip Removal

    Torque Specifications

    Table 1. Torque Specifications: Wheel Arch Liner - Front - LH (Remove and Replace)
    Description Torque Value Recommended Tools Reuse/Replace Notes
    Bolt that attaches the LH front wheel arch liner to the vehicle
    5 Nm (3.7 lbs-ft)
    • 10 mm socket
    		 Reuse

    Remove

    1. Remove the LH front wheel. See Wheel Assembly (Remove and Install).
    2. Remove the bolt and release the clips (x18) that attach the LH front wheel arch liner to the vehicle, and then remove the liner from the vehicle.
      5 Nm (3.7 lbs-ft)
      Note
      Newer vehicles might have fewer fasteners than pictured.
      Note
      Use of the following tool(s) is recommended:
      • 10 mm socket

    Install

    Installation procedure is the reverse of removal.