28/08/2024 23:33:33

Tesla Badge - Rear (Remove and Replace)

Correction code 12050702 0.24 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so.NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

'
  • 2024-08-29: Added a note to remind that the rear badge is not reusable due to the positioning problem.
  • 1453028-00-A Kit, Badge Removal
  • 1134703-00-A Fixture, Rear Badge, Model 3
Informational PurposesAn informational icon, calling your attention
Note
The badge is not reusable due to the positioning problem. If the badge is removed for any reason, it must be replaced with a new one.

Remove

  1. Prepare the badge removal tool with approximately 60 centimeters of monofilament line.
  2. Raise the trunk lid, and position the badge removal tool so that the monofilament line cuts under a corner of the rear Tesla badge.
  3. Move the badge removal tool in a sawing motion to separate the rear Tesla badge from the trunk lid.
  4. Use IPA wipes to clean all adhesive residue and debris from the trunk lid surface.

Install

  1. Open the trunk lid partially to accommodate the rear badge fixture.
  2. Install the rear badge fixture over the rear-view camera and onto the trunk lid, and then attach the fixture in place with tape.
  3. Peel the adhesive backing from the trunk badge, align the badge protective film to the locating posts of the fixture, and then press the badge to the trunk.
  4. Remove the protective film from the badge, and then remove the fixture from the trunk lid.
  5. Replace the protective film over the badge, use a pressure roller to wet-out the badge, and then remove the protective film.
  6. Use an IPA wipe to clean the badge and any remaining debris.
    Informational PurposesAn informational icon, calling your attention
    Note
    Make sure that all edges of the badge are securely affixed to the trunk lid surface.
  7. Close the trunk lid.