2020-10-16

Switch - Power Trunk - Interior (Remove and Replace)

Correction code 11352702 0.12 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so.NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

Torque Specifications

Table 1. Torque Specifications: Switch - Power Trunk - Interior (Remove and Replace)
Description Torque Value Recommended Tools Reuse/Replace Notes
Screws that attach the interior power trunk switch to the power trunk lid trim
1 Nm (.7 lbs-ft)
  • Torx T20 socket
  • Ratchet/torque wrench
Reuse

Remove

  1. Remove the power trunk lid trim. See Trim - Lid - Power Trunk (Remove and Replace).
  2. Disconnect the electrical harness from the interior power trunk switch.
  3. Remove the screws that attach the interior power trunk switch to the power trunk lid trim, and then remove the switch from the trim.
    1 Nm (.7 lbs-ft)
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • Torx T20 socket
    • Ratchet/torque wrench

Install

Installation procedure is the reverse of removal.