10/11/2022 16:31:07
Sensor - Radar - Front (Remove and Replace)
Correction code 17201502 1.74 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so.NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.
Remove
- Remove the front fascia. See Fascia - Front (Remove and Install).
- Release the clip that attaches the front radar sensor wiring harness to the front end carrier.
- Disconnect the electrical harness connector from the radar sensor.
- Release the clips that attach the radar sensor to the front radar sensor bracket, and then remove the sensor from the vehicle.
Install
- Install the front radar sensor into the bracket.
- Connect the front radar sensor electrical connector.
- Connect the front radar sensor wiring harness to the front end carrier clip.
- Install the front fascia. See Fascia - Front (Remove and Install).
- Reinstall the vehicle firmware. See Software Reinstall - Touchscreen.
- Perform the front radar sensor calibration procedure. See Sensor - Radar - Front (Calibration).