14/08/2024 22:36:18

Cover - Seat Back - 2nd Row Seat - RH (Remove and Replace)

Correction code 13081002 0.60 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so.NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

Remove

  1. Remove the 2nd row lower seat cushion. See Seat Cushion - Lower - 2nd Row (Remove and Replace).
  2. Remove the RH 2nd row seat side bolster. See Bolster - Side - Seat - 2nd Row - LH (Remove and Replace).
  3. Remove the RH 2nd row seat back. See Seat Back - 2nd Row - RH (Remove and Replace).
  4. Release the clip that attaches the electrical harness connector to the seat back hinge bracket.
  5. Remove the bolt that attaches the seat back hinge bracket to the RH seat back.
    45 Nm (33.2 lbs-ft)
  6. Release the clips that attach the 2nd row seat back bezel to the seat back.
  7. Remove the push clip and release the clips that attach the 2nd row seat latch bezel to the seat back.
  8. Unzip the RH 2nd row seat back cover, and then remove the cover from the seat.

Install

Installation procedure is the reverse of removal.