O-ring - Filler Neck - Reservoir - Windshield Washer (RHD) (Remove and Replace)
Correction code
17504102
0.06
NOTE: Unless otherwise explicitly
stated in the procedure, the above correction code and FRT reflect all of the work
required to perform this procedure, including the linked procedures. Do not stack correction codes unless
explicitly told to do so.NOTE: See Flat Rate
Times to learn more about FRTs and how they are created. To provide feedback on
FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when
performing the below procedure.
Remove
- Remove the windshield washer reservoir filler neck. See Filler Neck - Reservoir - Windshield Washer (RHD) (Remove and Replace).
- Use a flathead screwdriver to remove the O-ring from the filler neck.
Install
Installation procedure is the reverse of removal.