2023-07-20

Sun Visor - LH (Remove and Replace)

Correction code 15051002 0.06 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email ServiceManualFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure. See Ergonomic Precautions for safe and healthy working practices.

  • 2023-07-20: Added a video in Remove part.

Torque Specifications

Table 1. Torque Specifications: Sun Visor - LH (Remove and Replace)
Description Torque Value Recommended Tools Reuse/Replace Notes
Bolt that attaches the sun visor to the vehicle
3.5 Nm (2.6 lbs-ft)
  • Torx T25 socket
  • ¼ in std ratchet
  • ¼ in torque wrench (installation only)
  • 2 in extension
Reuse

Remove

Warning IconA warning icon, calling your attention to a possibly risky situation
Warning
The video(s) included in this procedure are meant as an overview for supplemental purposes only. Follow all of the steps listed in the procedure to avoid damage to components and/or personal injury.
  1. Release the clips (x4) that attach the sun visor bracket cover to the vehicle.
  2. Remove the fastener that attaches the sun visor to the vehicle.
    3.5 Nm (2.6 lbs-ft)
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • Torx T25 socket
    • ¼ in std ratchet
    • ¼ in torque wrench (installation only)
    • 2 in extension
  3. Disconnect the electrical connector from the sun visor.
  4. Remove the sun visor from the vehicle.

Install

Installation procedure is the reverse of removal.