27/02/2020 11:09:25

Side Shield - Inboard - Driver Seat (Remove and Replace)

Correction code 13074602 0.06 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so.NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

Remove

  1. Open the LH front door.
  2. Move the driver seat to the rearmost and lowest position.
  3. Open the rear RH door.
  4. Remove the inboard side shield:
    1. Release the front clip that attaches the inboard side shield to the seat inner seat rail.
    2. Release the rear portion of the inboard side shield from the inner seat rail, and then rotate the side shield upwards.
    3. Pass the buckle out through the slot on the inboard side shield, and then remove the inboard side shield from the vehicle.

Install

Installation procedure is the reverse of removal.