23/10/2024 23:55:00

SIM Card - Car Computer (HW2.5) (Remove and Replace)

Correction code 21152002 0.24 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so.NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

Remove

  1. Disconnect 12V power. See 12V/LV Power (Disconnect and Connect).
  2. Remove the front passenger knee airbag. See Airbag - Knee - Front Passenger (Remove and Replace).
  3. Use a trim tool to move the catch to the right, and release the SIM card from the slot in the car computer.
  4. Remove the SIM card from the car computer.
  5. Destroy the SIM card by cutting the card in half through the center of the gold pads, and then cut each piece into half, resulting in 4 pieces.
    Warning IconA warning icon, calling your attention to a possibly risky situation
    CAUTION
    It is mandatory to destroy the SIM card to protect user data.

Install

  1. Install the new SIM card into the car computer slot with the notch up and the gold pads facing away from the bulkhead.
    Informational PurposesAn informational icon, calling your attention
    Note
    If installing a non-Tesla SIM card, refer to Toolbox article 10088 for additional requirements. Additionally, customer must complete form SC-15-21-001.
    Warning IconA warning icon, calling your attention to a possibly risky situation
    CAUTION
    Make sure that the SIM card goes into the slot, before releasing your grip of the SIM card.
  2. Carefully press the SIM card fully into the slot, so that the catch engages.
    Warning IconA warning icon, calling your attention to a possibly risky situation
    CAUTION
    If using a thin tool to press the SIM card in, use the tool as shown.
  3. Install the front passenger knee airbag. See Airbag - Knee - Front Passenger (Remove and Replace).
  4. Connect 12V power. See 12V/LV Power (Disconnect and Connect).
    Informational PurposesAn informational icon, calling your attention
    Note
    For China only, after installment, make sure to authenticate the new SIM card. Refer to article 5655500 for details.