15/12/2023 01:27:58

Seal - Perimeter - HV Battery (Remove and Replace)

Correction code 16103002 3.48 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so.NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

Remove

  1. Informational PurposesAn informational icon, calling your attention
    Note
    There are two types of HV battery perimeter seals: an older platter perimeter seal, and a newer ancillary bay perimeter seal. These are referred to as platter type and ancillary bay type. This procedure removes both types, but installs only the ancillary bay perimeter seal.
  2. Remove the HV battery. See HV Battery (RWD) (Remove and Install).
  3. Remove and discard the HV battery perimeter seal.
    Informational PurposesAn informational icon, calling your attention
    Note
    When removing the platter perimeter seal, peel the seal to the side, at a 90° angle from the adhesive line.
    Figure 1. Platter Type
    Figure 2. Ancillary Bay Type
  4. Use IPA wipes to clean the adhesive and residue from the HV battery cover surface.
    Tip: Use a drill fitted with an adhesive eraser wheel to speed clean up.