20/06/2022 14:01:07

Release Cable - Charge Port (NA) (Remove and Replace)

Correction code 44013202 0.45 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so.NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

Remove

  1. Open all doors and lower the windows.
  2. Open the hood, trunk and charge port door.
  3. Remove 2nd row seat cushion. See Seat Cushion - Lower - 2nd Row (Remove and Replace).
  4. Disconnect 12V/LV power. See 12V/LV Power (Disconnect and Connect).
  5. Perform the charge port voltage check. See Charge Port Voltage Check.
  6. Remove the LH trunk side trim. See Trim - Side - Trunk - LH (Remove and Replace).
  7. Remove the charge port safety cap. See Safety Cap - Busbar - Charge Port to HV Battery (Remove and Replace).
  8. Push the manual release cable out of the retaining clip.
  9. Release the charge port manual release cable clip from the carrier assembly.
  10. Pry out the edge clip that attaches the manual release cable to the charge port assembly.
  11. Note the position of the rocker arm, and then carefully separate the rocker arm from the latch actuator assembly.
  12. Remove the manual release cable from the vehicle.

Install

Installation procedure is the reverse of removal.