30/05/2024 07:03:18

Hood (Remove and Replace)

Correction code 10100302 0.48 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so.NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

This procedure assumes the hood striker, hinges, bump stops, and plugs are undamaged. Inspect these components from the old hood and if necessary, replace with new parts.

Remove

  1. Release the clips that attach the LH and RH hood gas struts to the LH and RH hood strut brackets, and then set the struts aside.
    Figure 1. RH shown, LH similar
  2. With assistance, remove the nuts that attach the hood to the LH and RH hood hinges.
    Figure 2. RH shown, LH similar
  3. With assistance, remove the hood from the vehicle, and then place it on a padded surface.
  4. Remove the hood striker from the old hood. See Striker - Hood (Remove and Replace).
    Informational PurposesAn informational icon, calling your attention
    Note
    Do not mark the location of the hood striker on the old hood.
  5. Remove the nuts that attach the LH and RH hood strut brackets to the old hood, and then remove the brackets.
  6. Remove the LH and RH bump stops from the old hood.
  7. Remove the hood plugs (4x) from the old hood.

Install

Warning IconA warning icon, calling your attention to a possibly risky situation
CAUTION
If using this procedure to install an unpainted part, make sure to apply seam sealer to all seams prior to installing and painting the part. Refer to the Collision Repair manual for more information.
Tip: For instructions on how to align the hood, refer to Hood Alignment.
  1. Install the hood plugs on the new hood.
  2. Install the LH and RH bump stops on the new hood.
  3. Position the LH and RH hood strut brackets on the new hood, and then tighten the nuts that attach the brackets to the hood.
    15 Nm (11.1 lbs-ft)
  4. Position the hood striker on the new hood, and then hand tighten the bolts that attach the striker to the hood.
  5. With assistance, position the hood on the vehicle, and then hand tighten the nuts that attach the LH and RH hood hinges to the hood.
    Figure 3. RH shown, LH similar
  6. Support the hood with a hood prop.
  7. Position the LH and RH hood gas struts on the LH and RH hood hinges, and then install the clips that attach the struts to the hinges.
  8. Carefully close the hood, and then check hood fitment.
  9. Perform gap and flush adjustments on the hood assembly, if necessary.
  10. Tighten the nuts that attach the hood assembly to the LH and RH hood hinges.
    15 Nm (11.1 lbs-ft)
  11. Tighten the bolts that attach the hood striker to the hood assembly.
    18 Nm (13.3 lbs-ft)
  12. Clean the LH and RH hood hinge bolts and the surrounding area with isopropyl alcohol (IPA), and then let dry for at least 1 minute.
  13. If necessary, apply touch up paint matching the vehicle's body color to the LH and RH hood hinge studs/nuts.
  14. For China, Japan and Korea only: Install a new motor ID label on the hood.
  15. Clean the front of the hood with IPA, and then install a front Tesla badge. See Tesla Badge - Front (Remove and Replace).