14/02/2020 10:46:35

Link - Stabilizer Bar - Front - LH (Remove and Replace)

Correction code 31012002 0.18 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so.NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

Remove

  1. Remove the LH front wheel. See Wheel Assembly (Remove and Install).
  2. Remove and discard the nuts that attach the front LH stabilizer bar link to the stabilizer bar and damper, and then remove the link from the vehicle.
    98 Nm (72.3 lbs-ft)

Install

Installation procedure is the reverse of removal, except for the following:

Replace all nyloc nuts.