2024-04-19

Reinforcement Bracket - Underhood Storage Unit (Remove and Replace)

Correction code 15244674 0.18 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so.NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

  • 2024-04-19: Added steps of separating the cooling fan module isolation bracket from the old frunk reinforcement assembly and installing it to the new frunk reinforcement assembly.

Torque Specifications

Table 1. Torque Specifications: Reinforcement Bracket - Underhood Storage Unit (Remove and Replace)
Description Torque Value Recommended Tools Reuse/Replace Notes
Bolts (x2) that secure the underhood reinforcement bracket
16 Nm (11.8 lbs-ft)
  • Ratchet/torque wrench
  • 2 in extension
  • 10 mm socket
Reuse
Bolts (x4) that attach the cooling fan module isolation brackets to the frunk reinforcement assembly
6 Nm (4.4 lbs-ft)
  • Cordless Ratchet/Impact Driver
  • 10 mm 12-point deep socket
  • Ratchet/torque wrench
Reuse

Remove

  1. Remove the underhood storage unit. See Underhood Storage Unit (Remove and Replace).
  2. Remove the bolts (x2) that secure the underhood reinforcement bracket.
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • Ratchet/torque wrench
    • 2 in extension
    • 10 mm socket
  3. Release the harness clip, and then remove the underhood reinforcement bracket from the fan assembly.
  4. Remove the bolts (x4) that attach the cooling fan module isolation brackets to the frunk reinforcement assembly, and set the upper isolation brackets aside for re-installation to the new frunk reinforcement assembly.
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • Cordless Ratchet/Impact Driver
    • 10 mm 12-point deep socket
    • Ratchet/torque wrench

Install

  1. Install the bolts (x4) to attach the cooling fan module isolation brackets to the new frunk reinforcement assembly.
    6 Nm (4.4 lbs-ft)
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • Cordless Ratchet/Impact Driver
    • 10 mm 12-point deep socket
    • Ratchet/torque wrench
  2. Install the underhood reinforcement bracket to the fan assembly, and install the harness clip.
  3. Install the bolts(x2) that secure the underhood reinforcement bracket.
    16 Nm (11.8 lbs-ft)
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • Ratchet/torque wrench
    • 2 in extension
    • 10 mm socket
  4. Install the underhood storage unit. See Underhood Storage Unit (Remove and Replace).