27/01/2021 16:29:45

Mud Flap - LH (Remove and Replace)

Correction code 12207102 0.12 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so.NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

Remove

  1. Turn the steering wheel fully to the left to provide access to the working area.
  2. Remove the bolt that attaches the bottom of the mud flap to the lower rocker panel cover.
  3. Remove the screws and washers (1st generation kits) or push clips (2nd generation kits) that attach the mud flap to the wheel arch liner.
  4. Remove the mud flap from the vehicle.

Install

  1. 1st generation kits: Place washers over the screws, then install the screws and washers that secure the mud flap to the U-nuts in the front LH wheel arch liner.
    1.5 Nm (1.1 lbs-ft)
  2. 2nd generation kits:Align the holes in the mud flap/splash guard to the holes in the front wheel arch liner, and then insert the opened (plastic rivet pulled out) push clips into the holes. Once the push clips are fully inserted, push the plastic rivets in to close the push clips and lock the mud flap/splash guard in place.
  3. Install the bolt that attaches the bottom of the mud flap to the lower rocker panel cover.
    5 Nm (3.7 lbs-ft)
  4. Ensure the mud flap is aligned with the body. Make adjustments as necessary.