06/03/2024 22:41:04

Mirror - Rear View (Remove and Replace)

Correction code 15050202 0.06 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so.NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

  • 2023-07-20: Added a video in step 2 of Remove part.

Torque Specifications

Table 1. Torque Specifications: Mirror - Rear View (Remove and Replace)
Description Torque Value Recommended Tools Reuse/Replace Notes
Rear view mirror to windshield mount bolt
2.5 Nm (1.8 lbs-ft)
  • ¼ in std ratchet
  • Torx Security T20 socket
  • Wiha torque setter
  • Wiha TorqueVario-S 0.8 Nm - 2.0 Nm screwdriver (installation only)
Reuse

Remove

  1. Remove the lower quad camera cover. See Quad Camera Cover - Lower (Remove and Replace).
  2. Grip the rear view mirror stalk, and then turn counterclockwise to release the rear view mirror.
    Warning IconA warning icon, calling your attention to a possibly risky situation
    CAUTION
    Do not turn the rear view mirror itself.
    Warning IconA warning icon, calling your attention to a possibly risky situation
    Warning
    The video(s) included in this procedure are meant as an overview for supplemental purposes only. Follow all of the steps listed in the procedure to avoid damage to components and/or personal injury.
  3. Disconnect the electrical connector from the rear view mirror, and then remove the mirror from the vehicle.

Install

Installation procedure is the reverse of removal.