03/05/2023 15:02:01

Finisher - Vent (Remove and Replace)

Correction code 14057502 0.24 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so.NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

Torque Specifications

Table 1. Torque Specifications: Finisher - Vent (Remove and Replace)
Description Torque Value Recommended Tools Reuse/Replace Notes
Screws that attach the vent finisher to the IP carrier
2.3 Nm (1.7 lbs-ft)
  • Torx T20 socket
  • 4 in extension
  • Ratchet/torque wrench
Reuse

Remove

  1. Remove the LH instrument panel end cap. See End Cap - Instrument Panel - LH (Remove and Replace).
  2. Remove both the LH and RH air wave end caps. See End Cap - Air Wave - LH (Remove and Replace).
  3. Remove the main instrument panel decor trim. See Decor Trim - Instrument Panel - Main (Remove and Replace).
  4. Remove the screws that attach the LH side of the vent finisher.
    2.3 Nm (1.7 lbs-ft)
  5. Remove the screws that attach the RH side of the vent finisher.
    2.3 Nm (1.7 lbs-ft)
  6. Release the clips (x16) that attach the vent finisher, and then pull the finisher toward the rear of the vehicle to remove it.
    Informational PurposesAn informational icon, calling your attention
    Note
    The top pad must be lifted slightly in order to insert a trim tool, and then release the clips.

Install

Installation procedure is the reverse of removal.