2018-05-30

Trim - Lid - Trunk (Remove and Replace)

Correction code 15111902 0.06 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so.NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

Remove

  1. Open the trunk.
  2. Release the clips at the upper corners, then work around the trim to release the clips that attach the trunk trim to the trunk lid.
    Informational PurposesAn informational icon, calling your attention
    Note
    The clips (x4) closest to the rear window have a higher retention force; use a clip prytool, if necessary. Remove any broken clips from the trunk lid.
  3. Remove the trunk lid trim from the trunk lid, and then remove any remaining clips from the trunk lid.
    Informational PurposesAn informational icon, calling your attention
    Note
    If the trunk trim removed is to be later installed, remove all clips from the trim.

Install

  1. If reusing the same trunk lid trim, install new clips onto the trim.
  2. Align the trunk lid tabs with the slots on the trunk lid, and then press the clips into the trunk lid.