13/05/2020 16:12:13

Cap - Reservoir - Windshield Washer (Remove and Replace)

Correction code 17501202 0.06 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so.NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

Remove

  1. Remove the rear underhood apron. See Underhood Apron - Rear (Remove and Replace)
  2. Use a plastic trim tool to remove the cap from the windshield washer reservoir filler neck.
    Informational PurposesAn informational icon, calling your attention
    Note
    The cap and the retaining collar are a single piece.

Install

  1. Align the locating slot on the cap with the locating tab on the filler neck, and then fully seat the cap onto the filler neck.
  2. Install the rear underhood apron. See Underhood Apron - Rear (Remove and Replace)