2026-03-12

Rim - Steering Wheel (Remove and Replace)

Correction code 32051102 0.30 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure. See Ergonomic Precautions for safe and healthy working practices.

  • 2025-07-03: Removed the firmware reinstall step.

Torque Specifications

Table 1. Torque Specifications: Rim - Steering Wheel (Remove and Replace)
Description Torque Value Recommended Tools Reuse/Replace Notes
Screws (x4) that attach the bright surround to the steering wheel
2.5 Nm (1.8 lbs-ft)
  • Torx T20 socket
Reuse

Remove

  1. Remove the steering wheel. See Steering Wheel (Remove and Install).
  2. Disconnect the steering wheel heating element connector, if applicable.
  3. Release the clips (x3) that attach the horn switch to the steering wheel rim.
  4. Disconnect the connectors (x2), and then remove the horn switch from the bezel.
  5. Disconnect the electrical harness from the lower connector.
  6. Remove the screws (x4) that attach the bright surround to the steering wheel.
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • Torx T20 socket
  7. Release the clips that attach the steering wheel bezel assembly and horn switch to the steering wheel rim.
    Informational PurposesAn informational icon, calling your attention
    Note
    First pry up the lower portion away from the steering wheel, and then work around to release the other clips.

Install

  1. If the vehicle was not equipped with a heated steering wheel and the new steering wheel rim has a heating element, cut the steering wheel heating element connector.
    Informational PurposesAn informational icon, calling your attention
    Note
    Leaving the connector attached may cause NVH issues.
  2. Install the clips that attach the steering wheel bezel assembly and horn switch to the steering wheel rim.
  3. Install the screws (x4) that attach the surround to the steering wheel.
    2.5 Nm (1.8 lbs-ft)
    Informational PurposesAn informational icon, calling your attention
    Note
    Make sure that the bezel is properly installed into the rim.
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • Torx T20 socket
  4. Connect the electrical harness to the lower connector.
  5. Position the harness back to the horn switch, and then connect the connectors (x2).
    Informational PurposesAn informational icon, calling your attention
    Note
    Make sure the connectors are properly engaged.
  6. Install the clips (x3) that attach the horn switch to the steering wheel rim.
  7. Install the steering wheel. See Steering Wheel (Remove and Install).