20/01/2023 10:14:44

Airbag - Knee - Driver (Remove and Replace)

Correction code 20010202 0.36 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so.NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

Warning IconA warning icon, calling your attention to a possibly risky situation
Warning
Make sure 12V/LV power has been disconnected for at least 1 minute before disconnecting the electrical harness from Supplementary Restraint System (SRS) components, such as Restraint Control Module, sensors, airbags, etc. Failure to do so can result in unintended safety system behaviors. For more information on SRS precautions, see Airbag and Supplementary Restraint System (SRS) Precautions.
Informational PurposesAn informational icon, calling your attention
Note
The driver knee airbag is only equipped on North American vehicles.

Remove

  1. Remove the driver knee airbag. See Airbag - Knee - Driver (Remove and Install).
  2. Use a flat head screwdriver to apply pressure along the rear edge of the airbag assembly, and while doing so, flex the knee airbag cover surround to release each of the 5 airbag tabs from the cover surround.
  3. Pivot the airbag up, unhook the 6 tabs at the front of the airbag from the cover surround, and then remove the airbag from the cover.
    Warning IconA warning icon, calling your attention to a possibly risky situation
    CAUTION
    Properly dispose of the airbag.

Install

Installation procedure is the reverse of removal.