08/10/2024 17:33:57

Decor Trim - Instrument Panel - Main (Remove and Replace)

Correction code 14057002 0.12 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so.NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

Table 1. Torque Specifications: Decor Trim - Instrument Panel - Main (Remove and Replace)
Description Torque Value Recommended Tools Reuse/Replace Notes
Screws that attach the main decor trim to the LH and RH sides of the instrument panel
2.3 Nm (1.7 lbs-ft)
  • Torx T20 socket
  • 4 in extension
  • Ratchet/torque wrench
Reuse

Remove

  1. Remove the LH and RH instrument panel end caps. See End Cap - Instrument Panel - LH (Remove and Replace).
  2. Remove the LH and RH air wave end caps. See End Cap - Air Wave - LH (Remove and Replace).
  3. Remove the screws (x2) that attach the main decor trim to the LH and RH side of the instrument panel, if applicable.
    Tip: Use of the following tool(s) is recommended:
    • Torx T20 socket
    • 4 in extension
    • Ratchet/torque wrench
  4. Release the clips (x15) that attach the main instrument panel decor trim, and then remove the trim from the instrument panel.

Install

  1. Install the clips (x15) that attach the main instrument panel decor trim to the instrument panel.
  2. Install the screws (x2) that attach the main decor trim to the LH and RH side of the instrument panel, if applicable.
    2.3 Nm (1.7 lbs-ft)
    Tip: Use of the following tool(s) is recommended:
    • Torx T20 socket
    • 4 in extension
    • Ratchet/torque wrench
  3. Install the LH and RH air wave end caps. See End Cap - Air Wave - LH (Remove and Replace).
  4. Install the LH and RH instrument panel end caps. See End Cap - Instrument Panel - LH (Remove and Replace).